EasyManuals Logo

Hettich UNIVERSAL 32 User Manual

Hettich UNIVERSAL 32
49 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
CP : control panel, FC : frequency converter, SB : supply board, CB : cooling board, CC : control cable, LL : lid locking, BC : braking chopper,
BR : brake resistor, MR : mains reset
10/49
3. Requirements for error identification
3.1. Correct power supply
All fuses of house installation are intact.
Mains voltage is present on the following circuits:
Cable leading to mains cable
Appliance plug
Mains switch
Radio interference suppression filter
Supply board (SB) A1, plug X5, pin 1 and pin 5
3.2. Functional check
Mains switch is ON.
All LED`s on control panel must light up.
The centrifuge type and the software version number appears in the display.
After about 8 sec. the display switches over to
the most recently used centrifuging data or
the error code.
3.3. Procedure for diagnosing errors
Look for the displayed error code in the chapter 4 "Error messages".
Remedy the error according to the instructions.
Carry out a functional check after every repair and whenever a component is
replaced.
The technical data which were determined during the final check can be found in the
chapter 7 "Functional check".

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hettich UNIVERSAL 32 and is the answer not in the manual?

Hettich UNIVERSAL 32 Specifications

General IconGeneral
BrandHettich
ModelUNIVERSAL 32
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals