14
Units in feet and inches. Figures on the left of decimals
represent feet and those on the right represents feet in
percentile.
The magnitude of which is along the baseline in a point
projection measurement. The positive direction is from the
starting point to the terminal.
The magnitude of which deviates from the base line
horizontally in a point projection measurement.
Altitude of the target in a point projection measurement.
Maximum error of evaluated distance (used in resection
measurement)
Reference functions of common soft key
(Backspace)Delete one last character on the left of the
inserter in the edited column.
Delete all typed in the edited column.
End up the input in the current edited column and the
inserter goes to the next column. If there‟s only one or no
edited column in the dialogue box, the soft key „Enter‟ is
also used to accept the input and exit the dialogue box.
Go to Coordinate dialogue box and enter the coordinates
with keyboard
Retrieval coordinates of points from measured file
call coordinates of points from coordinate file
List the points in the current coordinate file to provide
to select the number for you.
List out details of the current record
Displays the name, code and coordinate of the current
station and back-sight station.
Set the height of the instrument and the target
Enter coordinates of the station where instrument is
placed.
Enter coordinates of the point where the target is.
Start rangefinders to measure distance
Start rangefinders when being under the Coordinate and
Distance mode. Then save the result of this measurement
and name of point which is added by one automatically.
The result cannot be saved when the compensator is
over .(Tilt over)
To Next Page
Loading...
