54
The Menu for staking out is as followed:
The „Setup Station‟ and „Orientation (BBS)‟ are the
preparation work for staking out. If you have already setup station
and orientation of „BBS‟, re-setting them are not necessary.
9.2.1 Staking out points
Stake out XX point
The coordinate point can be defined manually with keyboard
entering. It can be also defined by calling coordinates from
Measured points or Known points, which requires you to select a
file in advance ,otherwise the system will go to page for selecting
file automatically. You may also select file under this „Stake out:
XX‟ page by using starkey(★) function. If you have called
coordinates once, the system will enter the page which the you
have called coordinates from.
stakeout measurement
After defining the staking out coordinate, press „ENT‟ to
enter the interface of stakeout measurement.
HR:
dHR:
HD:
dHD:
dZ:
Meas Mode Coord. Next.P
Stake out:XX
N: m
E:
Z:
B.S M.Pt. Known Enter
To Next Page
Loading...
