68
3. Aim at the reference point and press „Select‟ to enter the
dialog of „REM-Altitude‟
4. Then turning the telescope up and down. The elevation
difference between the target and the reference point is displayed
in the VD column.
5. After the measurement, you have three opts:
„Set VA‟ :to re-enter the „REM-Altitude‟ page.
„HDist‟ :to re-measure the horizontal distance;
„ESC‟ t:o quit REM measurement.
9.4.2 MLM
Measure the horizontal distance (dHD), slope distance
(dSD), elevation difference (dVD) and azimuth angle (dHD)
between two target. You may also enter the coordinate or call
coordinate from files to calculate the value .
There are two modes of MLM:
1.MLM (A-B,A-C): measure A-B, A-C, A-D…. i.e the
starting point is the reference point of all following points.
REM-Altitude
VZ: 93°35′08″
HR: 169°11′14″
VD: -1.081m
Set VA HDist
REM-Base
VZ: 77°29′53″
SD: 169°11′14″
HD: 0.000m
Select
To Next Page
Loading...
