Hi-Target ZTS-320 Series - Default Chapter; Table of Contents

6
Catalogue
1.Uses of Total Station .................................................................... 9
2.Names and functions of the components ................................. 10
2.1 Names of components ............................................................. 10
2.2 Functions of keyboards and the display of information ........... 12
2.3 Functional keys under the basic measuring mode ................... 15
2.3.1 Angle Mode(including 2 menu pages) .............................. 15
2.3.2 Distance Mode(including two menu pages) ..................... 16
2.3.3 Coordinate Mode(including three menu pages) ............... 17
2.3.4 Explanation of Saving of data............................................ 18
2.4 Star(★) Key Mode ................................................................... 18
3. Initial Setup ............................................................................... 20
3.1 On & Off ................................................................................... 20
3.2 Set up the tilt correction of horizontal and vertical angles ...... 20
3.3 Set up the target Type .............................................................. 21
3.4 Set up the Reflecting Prism Constant. ...................................... 21
3.5 Signal ........................................................................................ 21
3.6 Set up the Atmospheric Correction ......................................... 21
3.6.1 Set up the Atmospheric Correction value (ppm) directly . 22
3.6.2 Calculate the Atmospheric Correction out with
temperature and pressure sensor ............................................. 22
3.7 The Correction of the Atmospheric refraction and the Earth
Curvature ....................................................................................... 22
3.8 Set up the minimum reading of the angle ............................... 23
3.9 Setup of Automatic Shutdown ................................................. 23
3.10 Set up the Addictive Constant and the Multiplying Constant 24
3.11 Selecting Data File ................................................................. 24
4. Preparations before measurements ......................................... 26
4.1 Unpacking and storing instruments ......................................... 26
4.2 Set up the instrument .............................................................. 26
4.2.1 Using plumbs to center and level (align)........................... 26
4.2.2 Using centering device to centre ...................................... 27
4.2.3 Loading and unloading of battery ..................................... 28
4.4 Reflecting Prism。 ................................................................... 29
4.5 Loading and unloading of the pedestal .................................... 30
4.6 Adjusting eyepiece lens of the telescope and aiming the
target. ............................................................................................ 30
4.7 Entering letters and numbers .................................................. 30
5. Angle Mode .............................................................................. 33
6. Distance Mode .......................................................................... 35
7. Coordinate Mode...................................................................... 37
8. Offset Mode .............................................................................. 41
8.1 Angle Offset Mode ................................................................... 41
8.2 Single-Distance Offset Mode .................................................... 42
8.3 Double-Distance Offset Mode .................................................. 44
8.4 Plane Offset Mode ................................................................... 45