44
Press „Meas‟ to start measurement.
After measuring, press ‟ENT‟ to enter the
„Offset(Dist1)-result‟ interface.
The result of the coordinate of the offset point will be
displayed on the screen, if you want to measure next point ,press
„NextP‟.If you want to save the result , press „Record‟.
Finally, press the key „ESC‟ to quit Distance Offset
measurement.
8.3 Double-Distance Offset Mode
It is specifically useful when the measured point is exactly
on the line of the two measurable points ,as well as the distance
between measured point and the two measuring point is known.
To Next Page
Loading...
