HID DTC4000 User Manual

DTC1000/1000M/4000/4500 Ethernet User Guide – Installation Guide L001411
(Rev.1.1)
16
Telnet Command
Command Purpose
Command Format
address.
mask
Store a new address
mask.
store net mask <MASK>
gateway
Store a new default
gateway.
store net gateway <ADDRESS>
dns
Store a new DNS
server address.
store net dns <ADDRESS>
domain
Store a new DNS
domain suffix.
store net domain <STRING>
opts
Enable or disable
automatic address
assignment using
DHCP. Static (non-
automatic) addresses
will come from the
stored or default
settings, depending on
the other settings.
To enable automatic address
assignment:
store net opts dhcp
To disable automatic address
assignment:
store net opts -dhcp
from
Restore the network
settings from either the
default settings or the
current settings.
store net from default|current
ifc
mode
Specify the Ethernet
interface mode as:
automatic, full or half
duplex; 10 or 100 mHz.
store ifc mode
auto|10half|10full|100half|100full
from
Set the Ethernet mode
settings from the
default or current
settings.
store ifc from default|current
save
Save all current
settings as the stored
settings in the
permanent memory.
save
load
Take the settings from
the stored memory and
make them the current
settings.
load

HID DTC4000 Specifications

General

Brand	HID
Model	DTC4000
Category	Printer
Language	English