HID FARGO HDP 6600 - Page 115

Printer Display Error Message Cause Solution
Calibrate Failed
Error Message No. 241
Lam left has failed calibration. Verify materials are installed in all stations.
Close the laminator lid and retry calibration.
N/A
Error Message No. 245
Laminator communication error. Verify that the firmware is up-to-date and all
cables are plugged in.
N/A
Error Message No. 246
Laminator comunication error. Reset the printer and try again. If this
problem persists, call for technical
assistance.
N/A
Error Message No. 247
Laminator communication error. Reset the printer and try again. If this
problem persists, call for technical
assistance.
Laminate Bad
Error Message No. 259
Right laminate material is bad. Most likely
invalid or corrupt RFID tag.
Install valid material.
Laminate Bad
Error Message No. 260
Left laminate material is bad. Most likely
invalid or corrupt RFID tag.
Install valid material.
Laminate Bad
Error Message No. 261
The material loaded in the right lam is not
suitable for the right lam.
Install valid material.
Laminate Bad
Error Message No. 262
The material loaded in the left lam is not
suitable for the left lam.
Install valid material.
Laminator Calibration Error
Error Message No. 329
Error lid open. Close the laminator cover.
Check Lam Hot Roller Lift
Error Message No. 331
Lift retract. Open the laminator cover and press on the
top of the lamination assembly to verify the
assembly is properly seated.
Check Lam Hot Roller Lift
Error Message No. 332
Lift engage (pressure). Open the laminator cover and press on the
top of the lamination assembly to verify the
assembly is propertly seated.
Heater Error - Cycle Power
Error Message No. 333
Laminator heater error. Reset the printer and try again. If this
problem persists, call for technical
assistance.
Heater Error - Cycle Power
Error Message No. 334
Laminator heater IR sensor error. Reset the printer and try again. If this
problem persists, call for technical
assistance.
Laminator Input Card Jam
Error Message No. 335
No card input sensor. Open the printer and laminator covers and
locate the card. Use the printer buttons to
remove the card or remove the card
manually.
Laminator Card Jam
Error Message No. 336
Card jam input sensor Open the printer and laminator covers and
locate the card. Use the printer buttons to
remove the card or remove the card
manually.
PLT-02931, A.4 115 November 2021
Powering
Trusted Identities
FARGO® HDP®6600 High Definition Card Printer/Encoder
User Guide