Printer Display Error Message Cause Solution
Laminator Card Jam
Error Message No.337
Card jam POS1 sensor. Open the printer and laminator covers and
locate the card. Use the printer buttons to
remove the card or remove the card
manually.
Laminator Card Jam
Error Message No. 339
Card jam at flipper. Open printer and laminator covers and locate
the card. Use the printer buttons to remove
the card or remove the card manually.
Laminator Flipper Jam
Error Message No. 340
Flipper jam Reset the printer and try again. Adjust lam
flipper Advanced settings if needed.
Laminator Rotator Jam
Error Message No. 341
Card jam at rotator. Open printer and laminator covers and locate
the card. Use the printer buttons to remove
the card or remove the card manually.
Laminator Rotator Jam
Error Message No. 342
Rotator jam Reset the printer and try again. Adjust Lam
Rotator Advanced settings if needed.
Reinstall Lam R Lamininate
Error Message No. 343
LAM right material not loaded. Load or reload material and try again.
Reinstall Lam L Laminate
Error Message No 344
LAM left material not loaded. Load or reload material and try again.
Lam R Lamination Jam
Error Message No. 345
LAM right lamination jam. Load or reload material and try again.
Lam L Lamination Jam
Error Message No. 346
LAM left lamination jam. Load or reload material and try again.
Lam R Laminate Failed to Release
Error Message No. 347
LAM right break patch error. Reload material and recalibrate lam sensors.
Lam L Laminate Failed to Release
Error Message No 348
Lam left break patch error. Reload material and recalibrate lam sensors.
Lam R. Cooling
Error Message No. 350
Laminator heater cooling. Reset the printer and try again. If this
problem persists, call for technical
assistance.
Lam R Laminate Out
Error Message No. 353
LAM right laminate material out. Load new material.
Lam L Laminate Out
Error Message No. 354
LAM left laminate material out. Load new material.
Lam R and Lam L Laminates Out
Error Message No. 355
LAM right and left laminate material out. Load new material.
Laminator General Error
ERror Message No. 356
Laminator state machine sequence error. Reset the printer and try again. If this
problem persists, call for technical
assistance.
Laminator General Error
Error Message No. 357
Patch state machine sequence error. Reset the printer and try again. If this
problem persists, call for techinical
assistance.
PLT-02931, A.4 116 November 2021
Powering
Trusted Identities
FARGO® HDP®6600 High Definition Card Printer/Encoder
User Guide
To Next Page
Loading...
