HID FARGO HDP 6600 - Page 117

Printer Display Error Message Cause Solution
Lam R Laminate Not at TOF
Error Message No. 358
Lam right material not at TOF. Calibrate laminator sensors. Adjust Laminate
Top of Form.
Lam L Laminate Not at TOF
Error Message No. 359
Lam left material not at TOF. Calibrate laminator sensors. Adjust Laminate
Top of Form.
Lam R Laminate Not Ready
Error Message No. 360
Lam right material not at POS1. Load or reload material and try again.
Lam L Laminate Not Ready
Error Message No. 361
Lam left material not at POS2. Load or reload material and try again.
Laminate Bad
Error Message No. 371
Right laminate material is bad. Most likely
invalid or corrupt RFID tag.
Change laminator material in right station
and retry.
Laminate Bad
Error Message No. 372
Left laminate material is bad. Most liely
invalid or corrupt RFID tag.
Change laminator material in left station and
retry.
Laminate Bad
Error Message No. 373
Right laminate material is bad. Most likely
invalid or corrupt RFIDtag.
Change laminator material in right station
and retry.
Laminate Bad
Error Message No. 374
Let laminate material is bad. Most likely
invalid or corrupt RFID tag.
Change laminator material in left station and
retry.
Laminate Bad
Error Message No. 375
Right laminate material is bad. Most likely
invalid or corrupt RFID tag.
Change laminator material in right station
and retry.
Laminate Bad
Error Message No. 376
Left laminate material is bad. Most likely
invalid or corrupt RFID tag.
Change laminator material in left station and
retry.
Laminate bad
Error Message No. 377
Right laminate material is bad. Most likely
invalid or corrupt RFID tag
Change laminator material in right station
and retry.
Laminate Bad
Error Message No. 378
Left laminate material is bad. Most likely
invalid or corrupt RFID tag.
Change laminator material in left station and
retry.
Laminator General Error
Error Message No. 379
I2c communication to printer has failed. Reset the printer and try again. If this
problem persists, call for technical
assistance.
Reinstall Lam R&L Laminate
Error Message No. 383
LAM left and right material not loaded. Load or reload material try again.
Remove Card
Error Message No. 384
Remove card from laminator. Open priinter and laminator covers and
locate the card. Use the printer buttons to
remve the card or remove the card manually.
IC Lam L Only
Error Message No. 385
IC cutout only allowed in left lam Remove IC material from the right station.
Lam R Cooling
Error Message No. 386
Laminator heater error Reset the printer and try again. If this
problem persists, call for technical
assistance.
Check Lam Power
Error Message No. 455
Lam is connected but not powered. Check lam power / connections and restart
the printer.
PLT-02931, A.4 117 November 2021
Powering
Trusted Identities
FARGO® HDP®6600 High Definition Card Printer/Encoder
User Guide