HID FARGO HDP 6600 - 6.3 Printer display icons

Printer Error Message Cause Solution
Mag Verify Error The printer is unable to verify encoded data. Check the cards and click Cancel Print on the
printer display.
No Ecard Encoder No smart prox card encoder is installed in
the printer.
To cancel, click Cancel Printon the printer
display.
Headlift Error The headlift sensor is not detecting
movement from the headlift cam. This can
occur for the printhead, transfer roller, or
card flattener.
Reboot the printer by cycling the power.
To cancel, press Cancel Printon the printer
display.
Waiting For Data
Job Data Error
Entire print job is unable to be sent to the
printer
Verify physical connection to the printer. To
cancel, press Cancel Printon the printer
display.
Heater Error The transfer roller or card flattener can not
achieve correct temperature.
To cancel, press Cancel Print on the printer
display. Reboot the printer by cycling the
power.
6.3 Printer display icons
This table identifies the icons on the printer display and their meaning.
Icon Description Notes
Initialization Screen The printer is initializing. The status bar at
the bottom of the screen indicates the
remaining time.
Ready Screen The printer is ready to be sent a job.
Low Ribbon / No Ribbon This icon is displayed in the upper right
portion of the Ready screen when the ribbon
material is low.
When there is not a ribbon installed, this
icon blinks three times then holds solid for
15 seconds in a continuous loop.
Low Film / No Film This icon is displayed in the upper right
portion of the Ready screen when the film
material is low.
When film material is not installed, this icon
blinks three times then holds solid for 1.5
seconds in a continuous loop.
PLT-02931, A.4 121 November 2021
Powering
Trusted Identities
FARGO® HDP®6600 High Definition Card Printer/Encoder
User Guide