Hidral PH-300 - Protective Bellows (Optional)

ASSEMBLY INSTRUCTIONS
PH-300 VERTICAL LIFTING PLATFORM
IM-560en
Vers. 05
Page 35
10. Protective bellows (optional)
Optionally, protective bellows can be supplied for the lower part of the vehicle,
made of waterproof and reproof PVC-coated polyester fabric and rigid PVC
reinforcements.
The bellows are only available on the sides where they are necessary so that users
cannot access the gap that exists below the platform, and two layout options can be
selected:
- Bellows on one side, corresponding to lower landing. Appropriate when there is a
wall nearby on the side with no landing.
- Bellows on two sides, on the lower landing side and on the side with no landing.
Appropriate when there is a wall nearby on the side with no landing.
180º 90º
One side
180º 90º
Two sides
1 Fix the bellows to the oor bottom with M4x10 countersunk screws.
2 Mark the position of the lower bellows xtures in the pit.
3 Lift the bellows and drill the pit to Ø6.
4 Insert the expansion plugs and x the lower part of the bellows to the pit with ST
4.2x32 screws.
M4x10
countersunk screw
ST 4.2x32
countersunk screw
Ø6 expansion plug