35
Editing the Device by the Operator
Purpose:
In the Device Management interface, for the operator, you can only view the details of the added device and
refresh it.
Click the added device in the Device Management interface. A pop-up box is shown in Figure 4.14.
Figure 4.14 Editing the Device
Viewing the Device
Steps:
Click Details to view the detailed information of the added devices including IP address, port, etc. The details of
the added devices are shown in Figure 4.15.
Figure 4.15 Viewing Device Information
For the operator, you cannot modify the detailed information of the devices.
Refreshing the Device
You can click Refresh to refresh the status of the added devices.
Controlling the Front Panel of Added DVR/NVR by the Operator
Purpose:
The keyboard can control the front panel of the added DVR/NVR.
Steps:
1. Click the added DVR/NVR in the Device Management interface. A box pops up as shown in Figure 4.16.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
