HIKVISION DS-19A08-F/Kx - Chapter 3 Keypad Operation (Local Operation); 3.1 Alarm Keypad Configuration

Control Panel User Manual
27
Chapter 3 Keypad Operation (Local
Operation）
3.1 Alarm Keypad Configuration
You should access the programming mode (only installer can access the
programming mode) before keypad configuration. The command is shown
below:
012345 *0#
1 2
{1} Installer password: 012345
{2} Command Key: *0 #
The command for exiting programming mode is *#.
3.1.1 Installer Password Settings
The password of installer is used for accessing programming and initializing
mode. The command is shown below.
000 012345 #
1 2 3
{1} Installer Password Programming Address: 000.
{2} Installer Password: The default password is 012345. The length of
the configured password should be 1~ 6 characte.