HIKVISION DS-19A08-F/Kx - Deleting All the Connected Wireless Device; Main Operator Password Changing; Control Programming Operation; Entering Partition

Control Panel User Manual
82
3.2.13 Deleting all the Connected Wireless Device
Follow the command below to delete all the connected wireless devices.
{password} + {*} + {92} + {#}
3.2.14 Main Operator Password Changing
The user password can be changed by main operator. The operations are
divided into following steps:
Steps:
1. {Master Code} } + {*} + {0} + {#}
2. {User Number} + {#}
3. {New Password} +{#}
4. {New Password}+{#}
The password will be changed by the above four steps
The User Number must be expressed into three digits, such as 002.
3.2.15 Control Programming Operation
The control panel can be configured via alarm keypad operation; configuration
process is generally divided into three steps:
Steps:
1. Enter the programming mode; see the command below:
{Installer Code} + {*} + {0} + {#}
2. Control panel configuration operation (see section 4.1)
3. Exit programming mode; see the command below:
{*} + {#}
3.2.16 Entering Partition
See the command below to enter the partition.
{*} + {3} + {n} + {#}