Control Panel User Manual
85
3.2.24 Control Panel Soft Recovery
For control panel soft recovery; see the command below:
{master code} + {*} + {6} + {8} + {#}
All unissued CID logs will not be reissued. Newly generated report will
be issued after system recovery.
The timer of the test report will not be cleared, and will remain the
value before recovery till the recovery processes being completed.
3.2.25 Current Fault Tone Disabling
To disable the current fault tone; see the command below:
{*} + {5} + {6} + {#}
If there are new faults, the prompt sound will re-Tip.
3.2.26 Test Report Manually Triggering
To trigger test report manually; see the command below:
{password} + {*} + {6} + {1} + {#}
One operation generates one test report. It is used to test the communication
between the control panel and center after installing the system or during the
inspection.
3.2.27 Keypad Locking and Unlocking
If a user failed to operate for five times, the keypad will be locked for 30
seconds. During the lock duration, the keypad backlight blinks and all of the
key operations are invalid. The keypad will be unlocked after 30 seconds.
3.2.28 Exiting the Operation
See the command below to exit the operation.
{*}{#}
To Next Page
Loading...
Need help?
General
