Control Panel User Manual
80
3.2.6 Group Bypass Recovery
After recovering the group bypass of a partition, all the alarm devices in
group-bypass supported zone of the partition will be revalidated. See the
command below.
{User Password} + {*} + {4} + {2} + {#}
3.2.7 Keypad Cancel Alarm
When the alarm is trigged, it can be canceled by keypad. The alarm can be
canceled both under the arming and the disarming status.
Alarm Clearing under the Arming Status
Operation Method: {User Password} + {*} + {1} + {#}
Alarm clearing under the disarming Status
Operation Method (1): {*} + {1} + {#}
Operation Method(2): {Users Password} + {*} + {1} + {#}
3.2.8 Alarm Output Operation
For enabling alarm output of the alarm keypad, see the command below.
{Password} + {*} + {8} + {5} + {n} + {#}
For disabling alarm output of the alarm keypad, see the command below.
{Password} + {*} + {8} + {6} + {n} + {#}
The control panel supports 16 channels of alarm outputs, the N valuation
should be 1-16.
3.2.9 Emergency Alarm
Press the {PANIC} button on the alarm keypad for 3 seconds or more. The
emergency alarm will be triggered after a double-beep sound.
To Next Page
Loading...
