Control Panel User Manual
64
{1} Non-zone Alarm Report Configuration Command Address: 680.
{2} White List Number. 01~08 indicate white list No.1~No.8.
{3} Enable/Disable the Non-zone Alarm Report
{4} Soft Zone Report
{5} System Status Report
{6} Alarm Clearing Report
{7} Testing Report
{8} Arming Report
{9} Disarming Report
{10} Control Panel Hijack Report
{11} Alarm Recovery Report
{12} Bypass Report
{13} Bypass Recovery Report
{4}~{13} Set the value as 1 to send the report. Set the value as 0 not to
send the report.
{14} End the command.
Partition Arming Permission Configuration
To configure the permission of partition arming, please refer to the command
below.
681 00 0 0 0 0 0 0 0 0 #
1
2 4 63 5
87
9
10
11
To Next Page
Loading...
