Safety Instrucon
These instrucons are intended to ensure that user can use the product correctly to avoid danger
or property loss.
Laws and Regulaons
●
The device should be used in compliance with local laws, electrical safety regulaons, and re
prevenon regulaons.
Electricity
●
In the use of the product, you must be in strict compliance with the electrical safety regulaons
of the naon and region.
●
The equipment shall not be exposed to dripping or splashing and that no objects lled with
liquids, such as vases, shall be placed on the equipment.
●
Provide a surge suppressor at the inlet opening of the equipment under special condions such
as the mountain top, iron tower, and forest.
●
CAUTION: To reduce the risk of re, replace only with the same type and rang of fuse.
●
The equipment must be connected to an earthed mains socket-outlet.
●
An appropriate readily accessible disconnect device shall be incorporated external to the
equipment.
●
An appropriate overcurrent
protecve device shall be incorporated external to the equipment,
not exceeding the specicaon of the building.
●
An all-pole mains switch shall be incorporated in the electrical
installaon of the building.
●
Ensure correct wiring of the terminals for connecon to an AC mains supply.
●
The equipment has been designed, when required,
modied for connecon to an IT power
distribuon system.
Baery
●
Do not ingest baery. Chemical burn hazard!
●
This product contains a coin/buon cell baery. If the coin/buon cell baer y is swallowed, it
can cause severe internal burns in just 2 hours and can lead to death.
●
Keep new and used
baeries away from children.
●
If the
baery compartment does not close securely, stop using the product and keep it away
from children.
●
If you think
baeries might have been swallowed or placed inside any part of the body, seek
immediate medical aenon.
●
CAUTION: Risk of explosion if the
baery is replaced by an incorrect type. Dispose of used
baeries according to the instrucons.
●
ATTENTION: IL Y A RISQUE D'EXPLOSION SI LA BATTERIE EST REMPLACÉE PAR UNE BATTERIE DE
TYPE INCORRECT. METTRE AU REBUT LES BATTERIES USAGÉES CONFORMÉMENT AUX
INSTRUCTIONS.
Network Camera User Manual
vi