HIKVISION DS-2CD3066G2-IS

The system switches day/night mode according to the schedule. It switches to day mode
during the set periods and switches to night mode during the other periods.
Sensivity
The higher the value of sensivity is, the more sensive the moon detecon is. If scheduled
image sengs is enabled, the sensivity of day and night can be set separately.
3.
Select an Area and click . Click and drag the mouse on the live image and then release the
mouse to
nish drawing one area.
Figure 6-1 Set Rules
4.
Click to clear all the areas.
5.
Click Save.
6.
Oponal: Repeat above steps to set mulple areas.
6.1.2 Normal Mode
You can set moon detecon parameters according to the device default parameters.
Steps
1.
Select Normal Mode in Conguraon.
2.
Set the Sensivity of normal mode. The higher the value of sensivity is, the more sensive the
moon detecon is. If the sensivity is set to 0, moon detecon and dynamic analysis do not
take eect.
3.
Set Detecon Target. Human and vehicle are available. If the detecon target is not selected, all
the detected targets will be reported, including the human and vehicle. This
funcon allows
alarm triggering by specied target types (human and vehicle).
Network Camera User Manual
37