HIKVISION DS-2CD3066G2-IS User Manual

2.
Select the port mapping mode to Manual, and set the external port to be the same as the
internal port.
3.
Click Save.
What to do next
Go to the router port mapping
sengs interface and set the port number and IP address to be the
same as those on the device. For more informaon, refer to the router user manual.
8.13.3 Set Port Mapping on Router
The following
sengs are for a certain router. The sengs vary depending on dierent models of
routers.
Steps
1.
Select the WAN
Connecon Type.
2.
Set the IP Address, Subnet Mask and other network parameters of the router.
3.
Go to Forwarding → Virtual Severs , and input the Port Number and IP Address.
4.
Click Save.
Example
When the cameras are connected to the same router, you can
congure the ports of a camera as
80, 8000, and 554 with IP address 192.168.1.23, and the ports of another camera as 81, 8001, 555,
8201 with IP 192.168.1.24.
Figure 8-1 Port Mapping on Router
Network Camera User Manual
56

HIKVISION DS-2CD3066G2-IS Specifications

General

Brand	HIKVISION
Model	DS-2CD3066G2-IS
Category	Security Camera
Language	English