Area Thermography
Congure the temperature measurement rule and monitor the maximum temperature of the area.
Steps
1.
Click and drag the mouse in the live view to draw the area and right click to nish drawing.
2.
Click and move the area to adjust the
posion.
3.
Drag the corners of the area to adjust the size and shape.
Go to Live View interface to view the maximum temperature and rule of the area in thermal
channel.
Set Temperature Measurement Shield Region
You can congure areas from being detected.
Steps
1.
Go to Conguraon → Local , and enable Display Shield Area.
2.
Check Enable Shield Area.
3.
Click .
4.
Drag the mouse in the live view to draw the area. You can drag the corners of the red rectangle
area to change its shape and size.
5.
Right click the mouse to stop drawing.
6.
Oponal: Select one area and click to delete it.
7.
Click Save.
7.1.4 Manual Thermography
Aer enable the manual thermography funcon of the device, you can click any posion on the
live view to show the real temperature.
Steps
1.
Go to
Conguraon → Local and select Display Temperature Info. as Yes.
2.
Go to Conguraon → Temperature Measurement → Basic Sengs .
3.
Check Enable Temperature Measurement.
4.
Click Save.
5.
Go to live view interface and select thermal channel, click
. Click any posion on the interface
to show the real temperature.
7.2 Fire and Smoke
Detecon
The device will trigger and upload alarm when detect the re source or smoke.
Thermal Opcal Bi-spectrum Network Camera User Manual
53