HIKVISION DS-2TD2637T-7/P

Detecon Funcon Parameter Descripon
Display a red frame around the re source
on stream when re occurs.
Sensivity
The higher the value is, the more easily the
re source of lower temperature can be
detected, and the higher the false alarm
rate is.
Smoke Detecon Display Smoke Source Frame on Stream
Display a red frame around the smoke
source on stream when smoke occurs.
Sensivity
The higher the value is, the more easily the
smoke can be detected, and the higher the
false alarm rate is.
Vericaon Sensivity
The higher the value is, the more quickly
the device can double-check and idenfy
the smoke, and the higher the false alarm
rate is.
Note
Smoke Detecon is not supported when Day/Night Switch mode is Night or when the device
idenes the environment as night.
5.
Oponal: Go to Smart Event → Smoke Detecon Shield . You can shield certain areas from
being detected in smoke
detecon, refer to Set Detecon Shield Region .
6.
Refer to Set Arming Schedule for seng scheduled me. Refer to Linkage Method Sengs for
seng linkage method.
7.
Click Save.
7.2.3 Set Dynamic Fire Source
Detecon
To avoid the potenal re damage, you can congure the re detecon funcon for certain areas.
The detail conguraon steps show as below.
Before You Start
Go to Conguraon → System → Maintenance → VCA Resource Type , select Temperature
Measurement + Perimeter
Protecon.
Thermal Opcal Bi-spectrum Network Camera User Manual
56