HIKVISION DS-3E1526P - Storm Control Configuration

Table 4-2 Parameters of Port Rate-Liming
Parameter Descripon
Sending Rate-Liming •
Rate-Liming: The data sending rate of the
port is limited.
• No
Rate-Liming: The data sending rate of
the port is not limited.
Sending Rate-Liming Value Only editable when the sending rate of the
port is limited.
The range is from 1 to 1000 Mbps.
Receiving Rate-Liming •
Rate-Liming: The data receiving rate of the
port is limited.
• No
Rate-Liming: The data receiving rate of
the port is not limited.
Receiving Rate-Liming Value Only editable when the receiving rate of the
port is limited.
The range is from 1 to 1000 Mbps.
3. Click Save to complete the conguraon.
4.1.4 Storm Control
Conguraon
Storm control prevents the ports from being disrupted by a broadcast, mulcast, or unknown
unicast storm. Errors in the protocol-stack
implementaon, or mistakes in network conguraon,
can cause a storm. The storm congests the network and degrades the network performance.
The packets passing from the port will be determined by the storm control if they are unknown
unicast,
mulcast, or broadcast. When the packets number exceeds the threshold, the incoming
data is dropped.
Steps
1. Go to Switch
Conguraon → Basic Conguraon → Port Conguraon → Storm Control .
Gigabit PoE Switch Web User Manual
10