HIKVISION DS-7316HUHI-K4 User Manual

Network Video Recorder User Manual
96
Configure Event Triggered Recording
Purpose:
You can configure the recording triggered by the motion detection, motion detection and alarm,
face detection, vehicle detection, line crossing detection, etc.
Go to System > Event.
Configure the event detection and select the channel (s) to trigger the recording when
event occurs. Refer to Chapter 11 Event and Alarm Settings and Chapter 13 VCA Event Alarm
for details.
Go to Camera > Encoding Parameters > Recording Parameters.
Set the event main stream/sub-stream recording parameters for the camera.
Go to Storage > Recording Schedule.
Select the recording type to Event.
Drag the mouse on the time bar to set the event detection recording schedule. Refer
to Chapter 7.4 Configure Recording Schedule for details.
Configure Alarm Triggered Recording
Purpose:
You can configure the recording triggered by the motion detection, face detection, vehicle
detection, line crossing detection, etc.
Go to System > Event > Normal Event > Alarm Input.
Configure the alarm input and select the channel (s) to trigger the recording when
alarm occurs. Refer to Chapter 11 Event and Alarm Settings and Chapter 13 VCA Event Alarm
for details.
Go to Camera > Encoding Parameters > Recording Parameters.
Set the event main stream/sub-stream recording parameters for the camera.
Go to Storage > Recording Schedule.
Select the recording type to Alarm
Drag the mouse on the time bar to set the alarm recording schedule. Refer to Chapter
7.4 Configure Recording Schedule for details.
Configure Picture Capture
Purpose:

HIKVISION DS-7316HUHI-K4 Specifications

General

Bit rate	10000 Kbit/s
Internal	No
Product color	Black
Video streaming	Yes
Maximum frame rate	30 fps
Audio input channels	4.0 channels
Audio output channels	2.0 channels
Audio formats supported	G.711 μ-law
Maximum video resolution	1920 x 1080 pixels
Video compression formats	H.264, H.265, H.265+
Number of simultaneously playbacked channels	16 channels
Audio input	RCA
RS-232 ports	1
BNC input ports	16
Alarm output channels	4
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
AC input voltage	100 - 240 V
Power consumption (typical)	65 W
Number of users	128 user(s)
Ethernet interface type	Gigabit Ethernet
Supported network protocols	TCP/IP, PPPoE, DHCP, Hik-Connect, DNS, DDNS, NTP, SADP, NFS, iSCSI, UPnP, HTTPS, ONVIF, SNMP
HDD interface	eSATA
Maximum HDD capacity	10000 GB
Operating temperature (T-T)	-10 - 55 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	390 mm
Width	445 mm
Height	70 mm
Weight	5000 g