All-in-One Network Video Recorder Quick Start Guide
6
Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact dealer.
This manual is applicable to the model: DS-7600NI-E1/A.
NVR Pre-Installation
The NVR is highly advanced surveillance equipment that should be installed with care. Please take into
consideration the following precautionary steps before installation of the NVR.
1. Keep all liquids away from the NVR.
2. Install the NVR in a well-ventilated and dust-free area.
3. Ensure environmental conditions meet factory specifications.
4. Use brackets for rack mounting.
5. Ensure there is ample room for audio and video cables.
6. When routing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
7. Ensure the NVR is grounded.
8. Environmental temperature should be within the range of 0 ºC to +50 ºC (32ºF to 122ºF).
9. Environmental humidity should be within the range of 10% to 90%.
NVR Installation
Purpose:
The product is a Network Video Recorder (NVR) as well as a LCD displayer. It can sit on the table or fixed in the
wall. Follow the steps to install the product.
Sitting on the Horizontal Plane
Steps:
1. Insert the bracket to the slot of the pedestal as the direction below. And make the four buckles tightly into the
slot.
2. Insert the combination of bracket and pedestal into the slot of the displayer. Until the circle hole in bracket is
totally matched with the circle bulge of displayer.
To Next Page
Loading...
Need help?
General
