Network Video Recorder User Manual
118
Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, face detection, etc.).
Select the Send Email alarm linkage action.
Trigger Alarm Output
The alarm output can be triggered by the alarm input, motion detection, video tampering
detection, face detection, line crossing detection, and all other events.
Go to the Linkage Action interface of the alarm input or event detection (e.g., motion
detection, face detection, line crossing detection, intrusion detection, etc.).
Click the Trigger Alarm Output tab.
Select the alarm output (s) to trigger.
Go to System> Event>Normal Event>Alarm Output.
Select an alarm output item from the list.
Refer to Chapter 11.7.3 Configure Alarm Output for the alarm output settings.
Configure PTZ Linkage
The system can trigger the PTZ actions (e.g., call preset/patrol/pattern) when the alarm event,
or VCA detection events occur.
Make sure the PTZ or speed dome connected supports PTZ linkage.
Go to the Linkage Action interface of the alarm input or VCA detection (e.g., face detection, line
crossing detection, intrusion detection, etc.).
Select the PTZ Linkage.
Select the camera to perform the PTZ actions.
Select the preset/patrol/pattern No. to call when the alarm events occur.
To Next Page
Loading...
Need help?
General
