Network Video Recorder User Manual
134
A PIR (Passive Infrared) alarm is triggered when an intruder moves within the detector vision
field. The heat energy dissipated by a person, or any other warm blooded creature such as dogs,
cats, etc., can be detected.
Go to System > Event > Smart Event.
Select a camera to configure.
Click PIR Alarm.
FIR Alarm
Check Enable PIR Alarm.
Optionally, check Save VCA Picture to save the captured pictures of PIR alarm.
Set the arming schedule. Refer to Chapter 11.1 Configure Arming Schedule.
Set the linkage actions. Refer to Chapter 11.2 Configure Alarm Linkage Actions.
Click Apply.
Thermal Camera Detection
The NVR supports the event detection modes of the thermal network cameras: fire and smoke
detection, temperature detection, temperature difference detection, etc.
Before you start
Add the thermal network camera to your device and make sure the camera is activated.
To Next Page
Loading...
Need help?
General
