Network Video Recorder User Manual
145
Select Receivers: Select the receiver. Up to 3 receivers can be configured.
Receiver: The name of the receiver.
Receiver's Address: The Email address of user to be notified.
Enable Attached Picture: Check to enable the function if you want to send email with attached
alarm images. The interval is the time between two adjacent alarm images.
Click Apply.
(Optional) Click Test to send a test email.
Configuring NAT
Purpose:
Two ways are provided for port mapping to realize the remote access via the cross-segment
network, UPnP™ and manual mapping.
UPnP
TM
Universal Plug and Play (UPnP™) can permit the device seamlessly discover the presence of other
network devices on the network and establish functional network services for data sharing,
communications, etc. You can use the UPnP™ function to enable the fast connection of the device
to the WAN via a router without port mapping.
Before you start:
If you want to enable the UPnP™ function of the device, you must enable the UPnP™ function of
the router to which your device is connected. When the network working mode of the device is set
as multi-address, the Default Route of the device should be in the same network segment as that
of the LAN IP address of the router.
Go to Menu > Configuration > Network > NAT.
UPnP™ Settings Interface
Check Enable UPnP.
Select Mapping Type as Manual or Auto.
To Next Page
Loading...
Need help?
General
