Fingerprint Time Attendance Terminal
47
After adding the device, some advanced parameters can be configured in the editing
device interface, e.g. downloading hardware parameters, reading hardware
parameters, time synchronizing, configuring access point, etc.
Steps:
1. In the device list, click Edit button to edit the information of the selected added
device.
2. Edit the basic parameters of the device on your demand, which are the same as
the ones when adding the device.
3. (Optional) Check the checkbox of Enable Holiday to enable the holiday
parameters when downloading permissions.
4. Click the Edit button to finish editing.
5. Click the Hardware Parameters Downloading button to download the updated
parameters to the local memory of the device.
Note: Capture function is not supported.
Editing Device (Door Information)
To Next Page
Loading...
Need help?
General
