HIKVISION DS-K1T6QT-F43 Series - Set Auto Attendance Via Device

Figure 7-14 Manual Aendance Mode
3.
Enable the Aendance Status Required.
4.
Enable a group of
aendance status.
Note
The Aendance Property will not be changed.
5.
Oponal: Select an status and change its name if required.
The name will be displayed on the T & A Status page and the authencaon result page.
Result
You should select an aendance status manually aer authencaon.
Note
If you do not select a status, the authencaon will be failed and it will not be marked as a valid
aendance.
7.9.3 Set Auto Aendance via Device
Set the aendance mode as auto, and you can set the aendance status and its available schedule.
The system will
automacally change the aendance status according to the congured schedule.
DS-K1T6QT-F43 Series Face Recognion Terminal User Manual
66