HIKVISION DS-K1T6QT-F43 Series

Figure 8-4 Add Wi-Fi
2) Enter Wi-Fi Name and Wi-Fi Password, and select Working Mode and
Encrypon Type.
3) Tap Save.
4.
Select the Wi-Fi name, and tap Connect.
5.
Enter the password and tap Save.
6.
Set WLAN parameters.
1) Set the IP address, subnet mask, and gateway. Or enable DHCP and the system will allocate
the IP address, subnet mask, and gateway
automacally.
2) Tap Save.
8.4.5 General
Sengs
Set Authencaon Parameters
Set Authencaon Parameters.
Steps
1.
Tap Conguraon → General Sengs → Authencaon Sengs .
DS-K1T6QT-F43 Series Face Recognion Terminal User Manual
78