Fingerprint Access Control Terminal·User Manual
17
Note: The picture displayed above is the Communication Settings interface. The models with -1
does not support Wi-Fi function. And the Wi-Fi module’s icon will not be displayed in the interface.
Setting Network
You can set the device network parameters, including the IP address, the subnet mask, the gateway
address, and the DHCP.
Steps:
1. Move the cursor to the Network and press the OK key to enter the Network interface.
2. Edit the IP address, the subnet mask, the gateway, and the DHCP.
Note: The device’s IP address and the PC’s should be in the same network segment.
3. Press the ESC key and select Yes to save the parameters.
To Next Page
Loading...
