HIKVISION DS-KH6320-WTE1 Configuration Guide

3.3.1 Set Indoor Staon Network Parameters
Network connecon is mandatory for the use of the indoor staon. Set the network parameters
aer acvang the indoor staon. Only when the IP address of the indoor staon is in the same
network segment as other devices, it can work properly in the same system.
Steps
Note
The default IP address of the indoor staon is 192.0.0.64.
Two ways are available for you to set IP address: DHCP, and set IP address manually.
1.
Tap Sengs → → Conguraon , and enter admin (acvaon) password.
2.
Tap
to enter the network sengs page.
Figure 3-17 Network Sengs
3.
Set the network parameters.
-
Enable DHCP, and the system can assign an IP address of the indoor staon automacally.
-
Disable the DHCP funcon, and set the IP address manually. You should set the device IP
address, the gateway, the DNS address.
Network Indoor Staon Conguraon Guide
16

HIKVISION DS-KH6320-WTE1 Specifications

General

Display Size	7 inch
Resolution	1024 × 600
Network Protocols	TCP/IP, SIP, RTSP
Audio Input	Built-in omnidirectional microphone
Audio Output	Built-in loudspeaker
Power Consumption	≤ 6 W
Operation Method	Touchscreen
Audio Compression Standard	G.711 U
Audio Compression Rate	64 Kbps
Wi-Fi Standard	IEEE802.11 b/g/n
Wi-Fi Frequency Range	2.4 GHz
RS-485	1
Working Temperature	-10 °C to 55 °C (14 °F to 131 °F)
Audio	Two-way audio
Power Supply	12 VDC, PoE (IEEE802.3af)
Installation	Wall-mounted
Display Type	TFT LCD
Network Interface	10/100 Mbps Ethernet
Alarm Output	1 channel
TF Card	up to 32 GB
Working Humidity	10% to 90%