HIKVISION DS-KH6320-WTE1 Configuration Guide

3.
Set SIP registraon password.
1) Tap Registraon Password.
2) Create a new SIP registraon password and conrm the password.
3) Tap OK.
4.
Oponal: Enable Compable with SIP 1.0 Indoor Staon and the indoor staon (SIP 2.0) can be
compable with SIP 1.0 indoor staon.
5.
Oponal: Enable standard SIP and you can access to the third party devices.
1) Slide to Enable Standard SIP.
2) Tap VOIP Account
Sengs and congure the account informaon, including the user name,
the phone number, the registered user name, the password, the domain, the port No., and
the
expiraon date.
Figure 3-23 VOIP Account Sengs
Note
Up to 32 characters are allowed in the user name.
3.3.6 Add Camera
Steps
1.
Tap Sengs → → Conguraon , and enter admin (acvaon) password.
2.
Tap
to enter the device management page.
3.
Tap + to pop up the dialog box.
4.
Select a protocol to add the camera.
-
Select HIK Protocol and you can add the camera depended on the HIK protocol.
Network Indoor Staon Conguraon Guide
22

HIKVISION DS-KH6320-WTE1 Specifications

General

Display Size	7 inch
Resolution	1024 × 600
Network Protocols	TCP/IP, SIP, RTSP
Audio Input	Built-in omnidirectional microphone
Audio Output	Built-in loudspeaker
Power Consumption	≤ 6 W
Operation Method	Touchscreen
Audio Compression Standard	G.711 U
Audio Compression Rate	64 Kbps
Wi-Fi Standard	IEEE802.11 b/g/n
Wi-Fi Frequency Range	2.4 GHz
RS-485	1
Working Temperature	-10 °C to 55 °C (14 °F to 131 °F)
Audio	Two-way audio
Power Supply	12 VDC, PoE (IEEE802.3af)
Installation	Wall-mounted
Display Type	TFT LCD
Network Interface	10/100 Mbps Ethernet
Alarm Output	1 channel
TF Card	up to 32 GB
Working Humidity	10% to 90%