HIKVISION DS-KH6320-WTE1 Configuration Guide

Wizard
Tap Wizard and set the language, network, indoor staon type, device No., and select a device
according to the wizard. Refers to
Quick Operaon (For Normal Device) for the details.
Preference
Tap Sengs → to enter the preference page.
Shortcut
Sengs
Enable call elevator, alarm, call management center, or leave message and the icon will be
displayed on the home page.
Zone Sengs
Note
Only when enable Alarm in the shortcut sengs, can the Zone Sengs displayed on the
Preference page.
Set the zone parameters. For details, see Zone Sengs .
Scene Sengs
Note
Only when enable Alarm in the shortcut sengs, can the Scene Sengs displayed on the
Preference page.
Set the scene parameters, including the stay mode, the away mode, the sleeping mode, or
customize the scene. For details, see Arming Mode Sengs .
3.9 Output
Sengs
You can set and control the connected output devices via the output sengs page. You can change
the relay' name, and open
duraon. You can also set to display the relay buon on the main page
or not.
Steps
1.
Tap Sengs → → Output Sengs .
Note
●
Supports up to 2 relays.
●
If no relays displayed on the page, the device may not support the funcon.
2.
Select a relay and set the parameters.
Name
You can change the relay's name.
Network Indoor Staon Conguraon Guide
39

HIKVISION DS-KH6320-WTE1 Specifications

General

Display Size	7 inch
Resolution	1024 × 600
Network Protocols	TCP/IP, SIP, RTSP
Audio Input	Built-in omnidirectional microphone
Audio Output	Built-in loudspeaker
Power Consumption	≤ 6 W
Operation Method	Touchscreen
Audio Compression Standard	G.711 U
Audio Compression Rate	64 Kbps
Wi-Fi Standard	IEEE802.11 b/g/n
Wi-Fi Frequency Range	2.4 GHz
RS-485	1
Working Temperature	-10 °C to 55 °C (14 °F to 131 °F)
Audio	Two-way audio
Power Supply	12 VDC, PoE (IEEE802.3af)
Installation	Wall-mounted
Display Type	TFT LCD
Network Interface	10/100 Mbps Ethernet
Alarm Output	1 channel
TF Card	up to 32 GB
Working Humidity	10% to 90%