HIKVISION DS-KH6320-WTE1 Configuration Guide

Tap Sengs → to enter the Wi-Fi Sengs page. Enable Wi-Fi. Select a Wi-Fi from the list and
enter the password of the Wi-Fi, and the indoor staon can connect to the Wi-Fi.
Figure 3-20 Wi-Fi Sengs
3.3.4 Set Indoor
Staon No.
Indoor staon No. and the indoor extension No. are numbers, which can be dialed by other devices
to call the indoor staon and the indoor extension in an intercom system. The indoor staon No., is
composed of the
oor No., room No., community No., building No. and unit No.
The indoor extension No. Should be a numeric from 1 to 5.
Up to 5 indoor extensions can be set for 1 indoor
staon.
Steps
1.
Tap
Sengs → → Conguraon → to enter the indoor staon No. sengs page.
Note
Default admin password is the acvaon password.
Network Indoor Staon Conguraon Guide
19

HIKVISION DS-KH6320-WTE1 Specifications

General

Display Size	7 inch
Resolution	1024 × 600
Network Protocols	TCP/IP, SIP, RTSP
Audio Input	Built-in omnidirectional microphone
Audio Output	Built-in loudspeaker
Power Consumption	≤ 6 W
Operation Method	Touchscreen
Audio Compression Standard	G.711 U
Audio Compression Rate	64 Kbps
Wi-Fi Standard	IEEE802.11 b/g/n
Wi-Fi Frequency Range	2.4 GHz
RS-485	1
Working Temperature	-10 °C to 55 °C (14 °F to 131 °F)
Audio	Two-way audio
Power Supply	12 VDC, PoE (IEEE802.3af)
Installation	Wall-mounted
Display Type	TFT LCD
Network Interface	10/100 Mbps Ethernet
Alarm Output	1 channel
TF Card	up to 32 GB
Working Humidity	10% to 90%