HIKVISION DS-KH6320-WTE1

3.
When you slide to disable Scene Password, there is no needs to enter password during scene
mode switching.
3.4.4 Modify Unlock/Duress Code
You can create and edit the duress code and unlock password of the indoor staon.
Steps
1.
Tap Sengs → → Conguraon , and enter admin (acvaon) password.
2.
Tap Password.
Figure 3-28 Unlock and Duress Code Sengs Page
3.
Tap Unlock Password or Duress Code to pop up the password sengs dialog box.
Unlock Password
Create the indoor
staon's unlock password. If the device has connected to a lock, enter the
password to unlock.
Duress Code
When you are hijacked and forced to open the door, you can enter the duress code. An alarm
will be triggered to
nofy the management center secretly.
Note
The duress code and the unlock password cannot be the same.
4.
Create a new password and conrm it.
5.
Tap OK to save the sengs.
Network Indoor Staon Conguraon Guide
28