HIKVISION DS-KH6320-WTE1 Configuration Guide

Room Informaon
You can set room name and No. Tap Advanced to set the community No., building No., and
unit No. if you need.
When calling the indoor staon and the two devices are in the same building, you can call the
room No. directly.
If
Live View
Duraon
You can set the duraon of live view.
Registraon Password
You can create a new SIP registraon password.
Enable SIP 1.0
You can enable SIP 1.0 protocol according to your needs.
3.3.5 SIP
Sengs
Devices can communicate with each other via SIP protocol. You create set the SIP register
password, enable standard SIP and set VOIP account.
Steps
1.
Tap
Sengs → → Conguraon , and enter admin (acvaon) password.
2.
Tap SIP Sengs in Local Informaon Page.
Figure 3-22 SIP Sengs
Network Indoor Staon Conguraon Guide
21

HIKVISION DS-KH6320-WTE1 Specifications

General

Display Size	7 inch
Resolution	1024 × 600
Network Protocols	TCP/IP, SIP, RTSP
Audio Input	Built-in omnidirectional microphone
Audio Output	Built-in loudspeaker
Power Consumption	≤ 6 W
Operation Method	Touchscreen
Audio Compression Standard	G.711 U
Audio Compression Rate	64 Kbps
Wi-Fi Standard	IEEE802.11 b/g/n
Wi-Fi Frequency Range	2.4 GHz
RS-485	1
Working Temperature	-10 °C to 55 °C (14 °F to 131 °F)
Audio	Two-way audio
Power Supply	12 VDC, PoE (IEEE802.3af)
Installation	Wall-mounted
Display Type	TFT LCD
Network Interface	10/100 Mbps Ethernet
Alarm Output	1 channel
TF Card	up to 32 GB
Working Humidity	10% to 90%