HIKVISION DS-KH6320-WTE1 Configuration Guide

3.
Select a device to link. Edit the following parameters.
Name
You can edit the name of the device.
Language
Select a language from the drop-down list for the device.
Network
Enable Auto Get IP Address and the system will assign IP address, subnet mask, and gateway
automacally. Or edit the IP address, subnet mask, and gateway manually.
Door Lock Parameters
Aer wire the lock with the door staon, you can set name and door opening duraon
according to your needs.
Note
Up to 2 locks can be congured.
Volume Sengs
Set microphone volume and output volume.
Call Number Sengs
The call No. should be the same as the indoor staon's room No. If press the call buon of
the door staon, you can call the indoor staon directly.
Public Password
You can use the public password to open the door staon related door lock. Select the public
password type. Enter the old password and new password and then
conrm the new
password. Tap OK to save the sengs.
Restore to Default Sengs
Restore All
All parameters will be restored to the factory sengs. The system will reboot to take
eect.
Device Reboot
Reboot the device.
3.3.3 Set Wi-Fi
Some indoor
staon support Wi-Fi connecon.
Note
Parts of models support seng Wi-Fi. For details, refers to actual product.
Network Indoor Staon Conguraon Guide
18

HIKVISION DS-KH6320-WTE1 Specifications

General

Display Size	7 inch
Resolution	1024 × 600
Network Protocols	TCP/IP, SIP, RTSP
Audio Input	Built-in omnidirectional microphone
Audio Output	Built-in loudspeaker
Power Consumption	≤ 6 W
Operation Method	Touchscreen
Audio Compression Standard	G.711 U
Audio Compression Rate	64 Kbps
Wi-Fi Standard	IEEE802.11 b/g/n
Wi-Fi Frequency Range	2.4 GHz
RS-485	1
Working Temperature	-10 °C to 55 °C (14 °F to 131 °F)
Audio	Two-way audio
Power Supply	12 VDC, PoE (IEEE802.3af)
Installation	Wall-mounted
Display Type	TFT LCD
Network Interface	10/100 Mbps Ethernet
Alarm Output	1 channel
TF Card	up to 32 GB
Working Humidity	10% to 90%