HIKVISION DS-KH6320-WTE1 Configuration Guide

Figure 4-5 System Maintenance
●
Reboot: Click Reboot and the system reboot dialog box pops up. Click Yes to reboot the system.
●
Restore Default Sengs: Click Restore Default Sengs to restore the default parameters. All
default
sengs, excluding network parameters, will be restored.
●
Restore All: Click Restore All to restore all parameters of device and reset the device to inacve
status.
Note
all default sengs, including network parameters, will be restored. The device will be reset to
inacvated status.
●
Import Conguraon File: Click Import Conguraon File and the import le window pops up.
Select the path of remote
conguraon les. Click Open to import the remote conguraon le.
The conguraon le is imported and the device will reboot automacally.
●
Export
Conguraon File: Click Export Conguraon File and the export le window pops up.
Select the saving path of remote conguraon les and click Save to export the conguraon
le.
●
Remote Upgrade: Click ... to select the upgrade le and click Upgrade to remote upgrade the
device. The process of remote upgrade will be displayed in the process bar.
●
Language: Select a language, and click Save to change the device system language.
Network Indoor Staon Conguraon Guide
47

HIKVISION DS-KH6320-WTE1 Specifications

General

Display Size	7 inch
Resolution	1024 × 600
Network Protocols	TCP/IP, SIP, RTSP
Audio Input	Built-in omnidirectional microphone
Audio Output	Built-in loudspeaker
Power Consumption	≤ 6 W
Operation Method	Touchscreen
Audio Compression Standard	G.711 U
Audio Compression Rate	64 Kbps
Wi-Fi Standard	IEEE802.11 b/g/n
Wi-Fi Frequency Range	2.4 GHz
RS-485	1
Working Temperature	-10 °C to 55 °C (14 °F to 131 °F)
Audio	Two-way audio
Power Supply	12 VDC, PoE (IEEE802.3af)
Installation	Wall-mounted
Display Type	TFT LCD
Network Interface	10/100 Mbps Ethernet
Alarm Output	1 channel
TF Card	up to 32 GB
Working Humidity	10% to 90%