HIKVISION DS-KH8520-WTE1 User Manual

4) Oponal: Enable Synchronize Language to synchronize the language of door
staon with indoor staon.
5) Tap OK to save the sengs.
6.
Tap Finish to save the sengs.
2.3 Conguraon Sengs
Conguraon sengs is required before starng using the indoor staon. It is
necessary to set the indoor staon network, room No., linked devices, device me
display, and so on.
2.3.1 Set Indoor Staon Network Parameters
Network connecon is mandatory for the use of the indoor staon. Set the network
parameters aer acvang the indoor staon. Only when the IP address of the
indoor
staon is in the same network segment as other devices, it can work properly
in the same system.
Steps
Note
The default IP address of the indoor staon is 192.0.0.64.
Two ways are available for you to set IP address: DHCP, and set IP address manually.
1.
Tap Sengs → → Conguraon , and enter admin (acvaon) password.
2.
Tap to enter the network sengs page.
Figure 2-6 Network Sengs
Video Intercom Indoor
Staon Conguraon Guide
6

HIKVISION DS-KH8520-WTE1 Specifications

General

Brand	HIKVISION
Model	DS-KH8520-WTE1
Category	Intercom System
Language	English