HIKVISION DS-KH8520-WTE1 - Network

3.
Select Device Type as Indoor Extension.
4.
Enter the required informaon.
Serial No.
Enter the device's serial No.. The serial No. is on the rear panel of the device
(A xed-length number with 9 digits).
IP Address
Enter the device's IP address.
Gateway
Enter the device's gateway.
Subnet Mask
Enter the device's subnet mask.
Password
Enter the device password, ranging from 8 to 16 characters in length.
No.
Enter the device No., ranging from 1 to 5.
5.
Click Save to enable the
sengs.
6.
Set SIP informaon.
Click
Congure Congure serial No., IP address, gateway, subnet mask,
password and No. of the device.
Click Delete Delete the SIP Number.
Click Clear Clear all SIP numbers.
Click Refresh Refresh SIP Informaon.
3.4.3 Network
Local Network Conguraon
Steps
1.
Click Local Network Conguraon to enter the conguring the local network
parameters page.
Video Intercom Indoor
Staon Conguraon Guide
39