HIKVISION DS-KH8520-WTE1 - Page 29

You can set and control the connected output devices via the output sengs page.
You can change the relay' name, and open duraon. You can also set to display the
relay buon on the main page or not.
Steps
1.
Tap Sengs → → Output Sengs .
Note
•
Supports up to 2 relays.
•
If no relays displayed on the page, the device may not support the funcon.
2.
Select a relay and set the parameters.
Name
You can change the relay's name.
Note
1 to 32 characters are allowed. Supports uppercase leers, lowercase leers,
numerics, and special characters.
Remain Open
Enable the
funcon, the relay remains open.
Disabled the funcon, and you can set the remain open duraon.
Note
•
By default, the funcon is disabled.
•
1 to 180 s are available to set.
Hide on Main Page
Enable the funcon and the relay buon will be displayed on the main page.
You can control the relay status manually on the main page.
Disabled the funcon and the relay buon will no be displayed on the main
page.
Video Intercom Indoor
Staon Conguraon Guide
20