Network Video Recorder User Manual
207
Chapter 15 HDD Management
15.1 Initializing HDDs
Purpose:
A newly installed hard disk drive (HDD) must be initialized before it can be used with your NVR.
A message box pops up when the NVR starts up if there exits any uninitialized HDD.
Figure 15-1 Message Box of Uninitialized HDD
Click Yes button to initialize it immediately or you can perform the following steps to initialize the
HDD.
Step 1 Go to Menu >HDD >General.
Figure 15-2 HDD Information Interface
Step 2 Select HDD to be initialized.
Step 3 Click the Init button.
Figure 15-3 Confirm Initialization
Step 4 Select the OK button to start initialization.
To Next Page
Loading...
