Hill-Rom MC700 User Manual

© 2014 by Hill-Rom Services, Inc. ALL RIGHTS RESERVED.
No part of this text shall be reproduced without written permission from Hill-Rom Services, Inc.
June 23, 2014 187155 REV 1 Page 1 of 10
Hill-Rom® MC700 General Ward Bed—
Central Brake System Replacement Instructions
Tools required: Hex wrench, 3mm Hex wrench, 4mm
Flat head screwdriver Needle nose pliers
Rubber mallet Torque wrench
Parts required: (1) 713528 Hex bar foot end
(1) 713529 Hex bar head end
(1) 710526 Central rod link weldment
(1) 710075 Transmission lever
(1) 172134 Transmission lever bariatric
(4) 187063 Bushing
(2) 711079 Grub screw
(2) 710066 Helmut cap
Removal
1. Adjust the bed height to access the base frame.
2. Set the brakes to Steer.
3. At the foot end, loosen, but do not remove, the grub screws (A, B) from the brake ped-
als (see figure 1).
Figure 1. Foot End Brake Pedal Screws
4. Set the brakes to Neutral.

Hill-Rom MC700 Specifications

General

Type	Medical Bed
Model	MC700
Manufacturer	Hill-Rom
Weight Capacity	500 lbs (227 kg)
Bed Length	84 inches (213 cm)
Height Adjustment	Electric
Power Requirements	120V, 60Hz
Side Rails	Yes
Trendelenburg Position	Yes

Summary

Removal

Loosen Foot End Brake Grub Screws

Loosen grub screws (A, B) at the foot end brake pedals without removing them.

Remove Foot End Brake Components

Remove brake pedal, plastic cap, hex bar foot end, and brake pedal from the foot end.

Remove Head End Brake Components

Remove helmet cap, plastic cap, hex bar head end, and helmet cap from the head end.

Access and Remove Head End Transmission Lever

Pull central link rod (K) to access and remove transmission lever (L) at the head end.

Remove Foot End Transmission Lever

Pull central link rod (K) and remove the transmission lever bariatric (N) from the foot end.

Position and Remove Central Link Rod

Rotate central link rod (K) and pull it out of the base frame tube.

Replacement

Install Foot End Hex Bar Assembly

Insert the new hex bar foot end (A) into the base frame tube (M).

Install Foot End Bushing Assembly

Install Head End Hex Bar Assembly

Install Head End Bushing Assembly

Install Head End Central Link Rod

Install Head End Transmission Lever

Install Foot End Transmission Lever

Position Foot End Lever and Hex Bar

Position Head End Lever and Hex Bar

Install Retainers and Brake Pedals

Install Foot End Grub Screw and Cover

Install Head End Grub Screw and Cover