Hills NVR-CH8 - Managing HDD Group; Setting HDD Groups; Setting HDD Property

User Manual of Network Video Recorder - User Manual
121
NetHDD will be displayed in the list.
Note:
If the added NetHDD is uninitialized, please select it and click the Init button for initialization.
9.3 Managing HDD Group
9.3.1 Setting HDD Groups
Purpose:
Multiple HDDs can be managed in groups. Video from specified channels can be recorded onto a particular HDD
group through HDD settings.
Steps:
1. Enter the Storage Mode interface.
Menu > HDD > Advanced
2. Set the Mode to Group, as shown in Figure 9. 5.
Figure 9. 5 Storage Mode Interface
3. Click the Apply button and the following Attention box will pop up.
Figure 9. 6 Attention for Reboot
4. Click the Yes button to reboot the device to activate the changes.
5. After reboot of device, enter the HDD Information interface.
Menu > HDD> General
6. Select HDD from the list and click icon to enter the Local HDD Settings interface.
7. Select the Group number for the current HDD.
Note:
The default group No. for each HDD is 1.
8. Click the OK button to confirm the settings.
9. In the pop-up Attention box, click the Yes button to finish the settings.
9.3.2 Setting HDD Property
Purpose: