Need help?Do you have a question about the Hills NVR-CH8 and is the answer not in the manual?
General| Video Input | 8 channels |
|---|---|
| Video Output | HDMI, VGA |
| Hard Drive Support | 1 SATA HDD |
| Maximum HDD Capacity | Up to 6TB |
| Video Compression | H.264 |
| Network Interface | 10/100M Ethernet |
| Power Supply | 12V DC |
Provides procedures for safely powering the NVR on and off.
Guides users through the initial setup process using a wizard.
Step-by-step guide for integrating network cameras with the NVR, covering online, PoE, and custom protocols.
Setting image quality, stream types, resolution, and other recording parameters.
Setting up recording times, event triggers, and recording types.
Setting up recording triggered by motion detection events.
Setting up recording triggered by external alarm inputs.
Setting up recording triggered by Video Content Analysis events.
Accessing and reviewing recorded video data through various search methods.
Exporting recorded video data to external devices using quick or normal export methods.
Configuring motion detection triggers, areas, and response actions.
Configuring external sensor input alarms and their associated actions.
Setting up alarms for loss of video signal from cameras.
Defining how the system responds to alarms, including display, audio, and email notifications.
Basic network configuration including IP address, gateway, and DNS.
Preparing new hard disk drives for use by initializing them.
Updating the NVR firmware via local backup device or FTP server.
Solutions for common operational problems and error messages.
To Next Page
