Hillstone SG-6000-E2800 - Table 1-23: USB Port Attributes; Table 1-24: Gigabit Copper Port Attributes; Table 1-25: SFP Port Attributes

21
Chapter 1 Introduction | Hillstone
Hillstone SG-6000 E-Series Hardware Reference Guide
USB Port
Hillstone device provides up to two USB host ports. Attributes for the USB port are
shown in the following table.
Table 1-23: USB Port Attributes
Attribute
Description
Connector
USB Type-A interface
Port Standard
USB 2.0 host interface
Negotiation Mode
1.1/2.0 autosensing
Gigabit Copper Port
Hillstone device provides several fixed gigabit copper ports; the gigabit Combo port
also supports the copper cable connection. Attributes for the gigabit copper port are
shown in the following table.
Table 1-24: Gigabit Copper Port Attributes
Attribute
Description
Connector
RJ-45
Port Standard
Auto-MDIX
Frame Format
Ethernet_II
Ethernet_SNAP
Negotiation Mode
10/100/1000Mbps autosensing
Full/half-duplex
SFP Port
Hillstone device supports SFP ports. The following table describes the attributes of
SFP port.
Table 1-25: SFP Port Attributes
Attribute
Description
Connector
SFP
Frame Format
Ethernet_II
Ethernet_SNAP
Negotiation Mode
SFP optical module
1000Mbps
SFP copper module
10/100/1000Mbps autosensing (some
only supports 1000Mbps)
Full / half-duplex
Caution: To avoid dust falling into the SFP socket, you should place a rubber dust cap
(originally in the accessory box) over the SFP port.
The SFP port has two types of interface transceiver module for you to choose: