Hillstone SG-6000-E2800 - Table 1-26: SFP Optical Module Attributes

22
Chapter 1 Introduction | Hillstone
Hillstone SG-6000 E-Series Hardware Reference Guide
 SFP optical module/transceiver
 Copper SFP transceiver
If you choose to use SFP optical module in SFP port, you should use LC-Type optical
connector. Hillstone device supports five types of 1000Base-FX SFP optical
modules. All optical modules are hot-swappable.
Table 1-26: SFP Optical Module Attributes
Attribute
Description
Short-
haul
Multimo
de
Optical
Module
(850nm)
Medium-
haul
Single-
mode
Optical
Module
(1310nm)
Long-haul
Single-
mode
Optical
Module
(1310nm)
Long-haul
Single-
mode
Optical
Module
(1550nm)
Ultra-long
Haul
Single-
mode
Optical
Module
(1550nm)
Connector
LC
Fiber Type
62.5/125
μm
multi-
mode
fiber
9/125μm
single-
mode fiber
9/125μm
single-
mode fiber
9/125μm
single-
mode fiber
9/125μm
single-
mode fiber
Maximum
Transmission
Distance
0.55km
10km
40km
40km
70km
Central
Wavelength
850nm
1310nm
1310nm
1550nm
1550nm
Optional
Factory Module
TRAN-SX
TRAN-LX10
TRAN-LX40
——
TRAN-LX80
Caution: When using the optical module of Hillstone Network factory, it is
recommended not to mix with other manufacturers' optical modules, otherwise some
abnormal problems may arise
If you choose to use copper SFP transceiver in SFP port, you should use crossover
or straight-through cable (i.e. standard Ethernet cable). The following table
describes the attributes of copper SFP transceiver.